XM-820 hot-melt Control

The XM-820 controllers allow path-related control of up to 8 hot-melt application guns even without external control (PLC). You can apply and repeat the same hot-melt tracks as often as desired on any packaging following the entry of the desired application patterns for all guns.

The controller is installed ideally where you are gluing your products. You are not taking an extra step. You are always ready. You only need to carry out a few actions to enter a new pattern when starting a new order and you can see the results of your entries immediately in front of you. You can add or switch off individual guns easily.

The controllers work independently on one hand but are also strong in terms of communications. They process external signals from light barriers, shaft encoders or other events. Two additional inputs and outputs take care of signal exchange with parent machines like alarm signals.